Varimixer manual Motor Removal Instructions Models W30-W150

Motor Removal Instructions

Models W30-W150

18INSTALL SPECIAL V-BELT (A).

19INSTALL FORK ASSEMBLY (X).

20INSTALL WASHERS (G) (H) AND NUT (J).DO NOT TIGHTEN NUT.

21START THE MIXER AND TIGHTEN THE NUT (J). DO NOT OVERTIGHTEN!

22ON THE FRONT PULLEY SET,THE STUD (K) ON THE VARISPEED COLLAR (L) MUST BE PLACED INSIDE THE LOWER FORK (M),AND ON THE REAR PULLEY SET OUTSIDE THE FORK (N).

23ADJUST THE SPEED BY TURNING THE THE STOP SCREWS (O) IN OR OUT.

24THE STOP SCREWS (O) ON THE SPEED LEVER SHOULD BE ADJUSTED SO THAT THE MEASUREMENT (P) IS 1-2MM ON THE FRONT AND REAR PULLEY,AT HIGH AND LOW SPEED,

RESPECTIVELY.TIGHTEN THE JAM NUTS (R) WHEN THE SPEED IS CORRECTLY ADJUSTED.