•If local codes permit, use a flexible stainless steel tubing gas connector,
rear of side
burner1/2” side burner gas pipe
2.Gently move Side Burner completely into enclosure.
3.Go to “Check and Adjust the Burners” section.
Check and Adjust the Burners
The burners are tested and
Checking and adjusting the burner flames requires removing the grate.
flexible gas connector
•
3.Open shutoff valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe.
valve open
valve closed
4.Test all connections by brushing on an approved non- corrosive
Low flame adjustment:
If flame goes out on the LO setting, the low flame setting must be adjusted.
Light the burner and turn control knob to its lowest setting and remove knob. Hold the valve stem with pliers and insert a thin flat blade screwdriver into the shaft. Watch the flame and slowly turn screwdriver counterclockwise. Adjust flame to the minimum stable flame. Replace control knob.
Reassemble grate.
valve stem
Assemble Cooking Area
1.Lift off cover and grate and set aside. Remove packing from around burners. Reinstall grate.
cover
grate
® Teflon is a registered trademark of E.I. Du Pont de Nemours and |
|
Company. | 7 |
7