KitchenAid KSBN220SSS Tools and Parts, Location Requirements, Product Dimensions, Tools needed

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

Tools needed

•Level

•Small flat-blade screwdriver

•Flat-blade screwdriver

•Phillips screwdriver

•Tape measure or ruler

•Slip-joint pliers

•Pipe wrench

Parts needed

•Gas line shutoff valve

•1/2” male pipe thread nipple for connection to pressure regulator

•L.P. gas-resistant pipe-joint compound

•CSA design-certified outdoor flexible stainless steel appliance connector

[4-5 ft. (1.2-1.5 m)] or rigid gas supply line as needed

•Noncorrosive leak detection solution

Parts supplied

• Convertible regulator set for 4” W.C. natural gas

WARNING

Fire Hazard

Do not use side burner near combustible materials. Do not store combustible materials near side burner. Doing so can result in death or fire.

Select a location that provides minimum exposure to wind and traffic paths. The location should be away from strong draft areas.

Do not obstruct flow of combustion and ventilation air.

WARNING

Fire Hazard

Do not install this side burner on or near combustible materials.

Doing so can result in death or fire.

Location Requirements

WARNING

Explosion Hazard

Do not store fuel tank in a garage or indoors.

Do not store side burner with fuel tank in a garage or indoors.

Failure to follow these instructions can result in death, explosion, or fire.

4

Product Dimensions

Clearance to combustible construction for built-in outdoor side burners:

•A minimum of 12” (30.5 cm) must be maintained between the sides and back and any combustible construction.

•A 12” (30.5 cm) minimum clearance must also be maintained below the cooking surface and any combustible construction.

12” (30.5 cm)

13-1/4”

(33.7 cm)

26” (66.0 cm)

25-1/2”(64.8 cm)

1/2”

male NPT

3-1/2”

(8.9 cm)

21-3/8”(54.3 cm)