CDC603A Aug.06-03

INSTALLATION

GB

 

 

 

PREPARATION

 

FIXING MATERIAL SUPPLIED Fig. 2

 

Only use screws and fixing material supplied!

 

A

2

L-shape brackets

 

B

2

base-plate

 

C

4

washer screw

 

D

4

nut

 

E

4

tapping screw

 

F2 dust protection sticker

G4 adhesive label

H4 bolt

REMOVING TRANSPORT SCREWS Fig. 1

1Remove the three transport screws from the underside of the CD changer.

2Clean around the three holes on the CD changer.

3Glue the supplied round stickers G over the holes to prevent dust entering the CD changer.

4Store the three transport screws in the supplied plastic bag.

■DETERMINE THE MOUNTING POSITION FOR THE CD CHANGER Possible locations are:

-in the luggage boot (trunk),

-in the glove compartment,

-under the seats or,

-behind the seats of a pick-up truck.

The installation must not interfere with the legroom or influence the safe driving of the vehicle.

If the CD changer is to be mounted in the luggage boot, first install the extension cable ( Fig. 15) between the dashboard and the luggage boot.

•Ensure that the plug at the dashboard side correctly fits the connector of the car radio adapter cable (or the cable already fitted to certain types of car radio).

•If you have to drill holes for the extension cable, ensure that the edges of the holes are free from swarf. Provide the holes with a grommet or piece of tape.

•Ensure that the cable is not bent at sharp angles and cannot be damaged by any moving parts in the vehicle.

•Determine the mounting position for the CD changer. Ensure that the CD cartridge can easily be inserted and removed!

•Do not mount the unit upside-down if mounted horizontally or at an angle of 45° (Fig. 3a or 3c), or on its side if mounted vertically (Fig. 3b).

•The opening for the CD cartridge must face upwards in case of vertical mounting (Fig. 3b).

3