CDC603A Aug.06-03

MOUNTING

GB

Caution: Take care not to drill into the fuel tank, the exhaust pipe system, the catalytic￿ converter or the cables laying behind or below any drilled holes!

MOUNTING IN THE LUGGAGE BOOT

1Fix bracket A on the side of the CD changer using the washer screw C(Figs. 7a-c).

2Fix the base plate with the long bolts H to the bracket using the nut D(Fig.8).

3If present, lift the carpet covering the floor of the luggage boot(Fig.9).

4Fix the base plate X2 to the chassis using tapping screw E.The base plate must be fixed to a flat surface.

If there is no flat surface in the luggage boot, a wooden mounting board (approx. 10 mm thick) under the carpet should be used instead of the base plates. (Fix the wooden mounting board to the car using three screws). In that case fix the brackets to the board (laying under the carpet) using screws.

1Remove the nuts D. Lift up the CD changer (Fig. 10).

2Lay the carpet over the base-plates (or the wooden mounting board) and cut four smallcrosses in the carpet. Press the long bolts through.(Fig.11).

3Check that the three transport screws have been removed from the underside of the CD changer!

4Mount the CD changer using the nuts D (Fig. 12).

MOUNTING IN SUSPENDED POSITION

The CD changer can also be mounted on the underside of a flat surface, e.g. the rear parcel shelf.

1Fix bracket A to the sides of the CD changer using the washer screw C(Fig.13).

2Place the CD changer in the mounting position (Fig.14).

3Mark positions for four mounting holes (with a felt-tip pen).

4Drill holes of 3.6 mm diameter in the marked positions.

5Check that the three transport screws have been removed from the underside of the CD changer!

6Hold the CD changer in place and attach it with the tapping screws E

5