meters will not correctly read the RMS voltage of a modified sine wave. Non-TRUE RMS meters will read about 20 to 30 volts low when measuring the output of this inverter. For accurate measurement of the output voltage of this unit, use a TRUE RMS reading voltmeter such as a Fluke 87, Fluke 8080A, Beckman 4410, or Triplett 4200.

115 volt AC Output

CAUTION: Rechargeable Devices

Certain rechargeable devices are designed to be charged by plugging them directly into an AC receptacle.

These devices may damage the inverter or the charging circuit.

When using a rechargeable device, monitor its temperature for the initial ten minutes of use to determine if it produces excessive heat.

If excessive heat is produced, this indicates the device should not be used with this inverter.

This problem does not occur with most battery-operated equipment. Most of these devices use a separate charger or transformer that is plugged into an AC receptacle.

The inverter is capable of running most chargers and transformers.

CARE AND MAINTENANCE

Storage

1.Ideal storage temperature range is 50-68°F (10-20°C).

2.Store and use the inverter in a cool, dry place with adequate ventilation for all-around air circulation.

3.Avoid locations that are exposed to heating units, radiators, direct sunlight, or excessive humidity or dampness.

Fuse Replacement

If the inverter is overloaded, and the green LED is not lit, the internal 10 amp fuse may be blown.

1.Unscrew the flange of the inverter (counterclockwise).

2.Remove the end contact, flange and fuse.

3.Inspect the fuse to see if it is good or blown.

4.Replace with a new 10 amp fuse, if needed.

5.Carefully reassemble the fuse, end contact and flange. Do not overtighten the flange (turning clockwise).

COMMON AUDIO/VISUAL PROBLEMS

Problem: Buzzing Sound In Audio Systems

Some inexpensive stereo systems and boom boxes make a buzzing sound when operated from the inverter, because the power supply in the electronic device does not properly filter the modified sine wave produced by the inverter. The only solution to this problem is to use a sound system that has a higher quality power supply.

Problem: Television Interference

The inverter is shielded to minimize interference with TV signals. However, in some instances, some interference may still be visible, especially when the TV signal is weak. Try the following to improve the picture:

1.Move the inverter as far away as possible from the TV set, the antenna, and the antenna cables. Use a short AC extension cord, if necessary.

2.Adjust the orientation of the antenna cables, and the TV power cord to minimize interference.

3.Make sure the antenna feeding the TV provides an adequate (snow free) signal and that high quality, shielded antenna cable is used.

COMMON POWER OUTPUT PROBLEMS

Possible Causes

Recommendations

Battery voltage

Recharge battery or check

below 10 volts.

DC power supply.

Equipment being operated

Reduce load to maximum 100 watts.

draws too much power.

 

Inverter in thermal

Allow inverter to cool down. Ensure there is

shutdown condition.

adequate ventilation around unit, and load is

 

no more than 100 watts for continuous operation.

Main fuse failed (blown).

Replace fuse in DC connector.

Inverter is overloaded.

Reduce load to 100 watts max.

 

to maintain regulation.

SPECIFICATIONS

Power :

100 watts

AC Output:

115 volts, 60 Hz

DC Input:

13.8 volts

Fuse:

10 amps

Waveform:

Modified Sine Wave

6

7

Page 4
Image 4
Vector BD022806 Care and Maintenance, Common AUDIO/VISUAL Problems, Common Power Output Problems, Specifications