VEC022 Manual_Final_073106.qxp 7/31/06 6:36 PM Page 4
CAUTION: Caution statements advise against certain conditions and practices that may result in damage to vehicles, appliances and/or the Jump- Starter.
IMPORTANT:
Although this unit is delivered in a partially charged state, you must fully charge it with the supplied 110/120 volt AC charger for a full 48 hours before using it for the first time. You cannot overcharge the unit using the AC charger method.
1.Use only the supplied cords/adapters for recharging this unit. Do not recharge for more than
2.All On/Off switches should be in the OFF position when the unit is charging or not in use. Make sure all switches are in the OFF position before connection to a power source or load.
3.Never insert anything other than the supplied power/recharging cords or recommended appliance power/recharging cords into the 12 volt DC charging/power outlet on this unit. Do not use any accessory that is not recommended or provided by the manufacturer.
4.Do not use this unit to operate appliances that draw more than 5 amps.
5.This system is designed to be used only on vehicles with 12 volt DC battery systems. Do not connect to a 6 volt or 24 volt battery system.
6.This system is not designed to be used as a replacement for a vehicular battery. Do not attempt to operate a vehicle that does not have a battery installed.
7.Vehicles that have
8.Excessive engine cranking can damage a vehicle’s starter motor. If the engine fails to start after the recommended number of attempts, discontinue
9.Although this unit contains a
10.Check unit periodically for wear and tear. Replace worn or defective parts immediately. Contact Vector Customer Service department
11.Do not attempt to
12.Never submerge this unit in water.
4