VEC022 Manual_Final_073106.qxp 7/31/06 6:36 PM Page 9

CAUTION:

If engine fails to start, leave ignition key turned off and disconnect the negative (-) clamp first, then the positive (+) clamp. Try again later – the engine may be flooded.

Recharge jump-start system after each use.

WARNING:

Always disconnect the engine or frame jumper clamp first; followed by the battery jumper clamp

Never allow red and black clamps to touch each other or another common metal conductor; this could cause damage to the unit and/or create sparking/explosion hazard

There is a risk of explosive gases being released when batteries are charged or discharged. Failure to follow instructions may cause property damage, explosive hazard, and/or personal injury

Always use protective eyewear when using this product: contact with battery acid may cause blindness and/or severe burns

Keep out of children’s reach

ALWAYS store battery clamps on clamp tabs when not in use. Never touch battery clamps together, this can cause dangerous sparks, power arcing and/or explosion

FIRST AID:

SKIN: If battery acid comes in contact with skin, rinse immediately with water, then wash thoroughly with soap and water. If redness, pain, or irritation occurs, seek immediate medical attention

EYES: If battery acid comes in contact with eyes, flush eyes immediately for a minimum of 15 minutes and SEEK IMMEDIATE MEDICAL ATTENTION

3.CHARGING/RECHARGING

For maximum battery life, we recommend the VECTOR® system be kept fully charged at all times. If the battery is allowed to remain in a discharged state, battery life will be shortened.

NOTE: Recharging battery after each use will prolong battery life; frequent discharges between recharges will reduce battery life

IMPORTANT:

MAKE SURE ALL SWITCHES ARE TURNED OFF DURING RECHARGING

Charge unit for full 48 hours using AC method, prior to first use

Recharge unit fully after each use

Recharge unit once a month when not in use

9

Page 9
Image 9
Vector VEC022 owner manual Charging/Recharging, First AID