VEC1026BD_Manual_050305 5/9/05 2:25 PM Page 6
4.AC Power Ground Fault Circuit Interrupt (GFCI) — A
5.Internal protective circuits including:
•Overload and
•AC
•Low voltage shutdown
•A new cooling technology that more efficiently cools the power transistors and, combined with soft start, dramatically increases reliability and product life
AC Power Supply Controls and Indicators
The Inverter ON/OFF Switch turns the AC power circuitry on and off. The ON/OFF switch can also be used to reset the AC power after shutdown due to overvoltage, overload or
AC Power Supply Operation
1.Turn power switch to ON (the power indicator lights).
2.Plug in appliance and turn the appliance on.
Note: The AC power supply shuts down automatically when the battery voltage level is too low. If the LED flashes, a faulty condition such as an overload, overheating or short circuiting has occurred. Turn the AC Power Supply off and unplug the appliance. Wait a few minutes, then turn power back on.
USING THE EMERGENCY AREA LIGHT
The Area Light is controlled by the ON/OFF slide switch directly above it on the front panel. Make sure the light is turned OFF when the unit is being recharged or stored.
CARE AND MAINTENANCE
CAUTION
If the cord, wires, or cables become damaged, do not attempt to use. Return the entire unit to Vector Manufacturing for service and repair.
Replacement Parts
For replacement parts (bulbs, batteries, fuses, etc.), contact Customer Service
Battery Replacement/Disposal
It is recommended that the unit be returned to Customer Service for battery replacement. Contact
This unit contains a
WARNINGS
Do not dispose of the battery in fire, as this may result in an explosion.
Before disposing of the battery, protect exposed terminals with
Do not expose battery to fire or intense heat, as it may explode.
Fuse Replacement (DC Accessory Adapter)
1.Remove plug from accessory receptacle. Remove the gold cap by turning counterclockwise and lifting off.
2.Remove center pin and spring. Remove fuse.
3.Replace fuse with same type and size fuse.
4.Replace center pin and spring inside plug.
5.Replace gold cap by turning clockwise.
SPECIFICATIONS
Jumper Cables: | #6AWG welding cables |
Instant Starting Amps: | 300 amps |
AC Power Output: | 250 watts AC |
DC Power Output: | 12 volts DC |
Battery |
|
AGM: | 12 volt, 9 amp hour, sealed |
Accessory Outlet |
|
Protection: | Automatic overload protection |
6 | 7 |