750 Watt

Power Inverter

Vehicle Power System

Converts DC Vehicle Power
to 115 Volt AC Household Power
VEC1043

USER’S MANUAL

& WARRANTY INFORMATION

TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTAND
THIS INSTRUCTIONAL MANUAL. THIS MANUAL CONTAINS IMPORTANT
INFORMATION REGARDING THE OPERATION AND WARRANTY OF THIS
PRODUCT. PLEASE RETAIN FOR FUTURE REFERENCE.
www.vectormfg.com
8
Fault Protection Code and Troubleshooting Guide
INVERTER POWER SWITCH TURNED ON
SPECIFICATIONS
Output Connection: North American standard outlet
Output Voltage: Approx. 115 volts AC, RMS 60 Hz
Output Current: 6.5 amps Max
Output Waveform: Modified Sine Wave
Input Voltage: 12.5 volts DC
Low Voltage Alarm: 11.0 volts DC
No Load Input Current: 0.7 amps max.
Input Fuses: Internal
Input Cables: Battery clip cables
Additional Protection: Overload, overvoltage, overheating
Trouble/Indication Possible Cause Suggested Remedy
No AC output — yellow
LED lit DC input is below
10 volts Recharge or replace the
battery.
No AC output — red LED
lit Excessive appliance
load Reset unit by turning OFF,
then back ON.
Inverter hot Disconnect load from
inverter. Operate inverter
without load for a few
minutes. Reconnect load.
No AC output — green
LED not lit Bad connection or
wiring Tighten all DC connections.
Low battery alarm sounds Low battery voltage Recharge battery. Remove
load from inverter while
recharging battery.
Motorized power tool will
not operate Excessive start-up load If appliance does not start,
appliance is drawing too
much voltage and will not
work with this inverter.
Motorized power tool
does not operate at
correct speed
Purely inductive load Make the load not purely
inductive (i.e., operate an
incandescent lamp at the
same time as power tool).
Television/radio
interference Snow in picture,
“buzzing” sound Keep inverter and antenna
distant from each other.
Use shielded antenna.
Connect antenna to
amplifier.
VEC1043_ManualEN_091505 1/17/06 5:49 PM Page 8