|
| CONTENTS |
|
1. | INTRODUCTION | . .1 | |
2. | FEATURES | 1,2 | |
3. | OPERATION | . .2 | |
4. | RECHARGE | . .2 | |
| 4.1 | AC Recharge | . .3 |
| 4.2 | DC Recharge | . .3 |
5. | MAINTENANCE/PARTS REPLACEMENT | .3 | |
6. | SPOTLIGHT BULB REPLACEMENT | .4 | |
| 6.1 | SPOTLIGHT Bulb Removal | . .4 |
| 6.2 | Spotlight Bulb Installation | . .4 |
7. LANTERN TUBE REPLACEMENT . . . . . . . . . . . . . . . . . . . . . .5
7.1 Fluorescent Tube Removal . . . . . . . . . . . . . . . . . . . . . . .5
7.2 Fluorescent Tube Installation . . . . . . . . . . . . . . . . . . . . . .6
8. FUSE REPLACEMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
9. BATTERY REPLACEMENT . . . . . . . . . . . . . . . . . . . . . . . . .6,7
9.1 Battery Removal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
9.2 Battery Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
10. SAFE BATTERY DISPOSAL . . . . . . . . . . . . . . . . . . . . . . . . . .7
11. SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
WARRANTIES
CAUTIONS:
•DO NOT SUBMERGE IN WATER. This unit is not waterproof— it is water resistant.
•Do not recharge with other than supplied AC and DC Recharge Adapters.
•Do not overcharge battery.
•Do not operate lights while AC
•This spotlight produces high levels of heat when
•Keep spotlight lens away from combustible materials when spotlight is On.
•This light is not a
9.1 BATTERY REMOVAL PROCEDURE
1.Press the tab on the lower part of the Battery Compartment Cover while lifting the cover.
2.Fully remove the cover and set it aside.
3.Carefully move the battery towards the opening of the compartment.
4.Using a long nose pliers, carefully rock each spade terminal and remove them from the Battery Spade Lug Terminals. Note the colors of the attached wires and which terminal they were connected to.
5.Fully remove the battery and set it aside.
6.Follow Safe Battery Disposal instructions
9.2 BATTERY INSTALLATION PROCEDURE
1.Partially insert the new battery in the compartment in the same position as the old battery was.
2.Using the long nose pliers, attach the Spade Connectors to their respective Battery Spade Terminals. Check to ensure they are fully connected.
3.Push battery back into compartment.
4.Replace cover and slide downward until the tab snaps into place.
5.Momentarily check operation of the spotlight and lantern for proper operation.
6.Recharge the battery using either the AC or DC Recharge Adapter.
10.SAFE BATTERY DISPOSAL
Contains a
BATTERY DISPOSAL WARNINGS
•Do not dispose of the battery in fire as this may result in an explosion.
•Before disposing the battery, protect exposed terminals with
•Do not expose battery to fire or intense heat as it may explode.
11.SPECIFICATIONS
Spotlight
SPOTLIGHT POSITION | 13.5" H X 7.5" D X 5.5" W |
. . . . . . . . . . . . . . . . . . . . . . . . . . . .(3.42 mm x 1.9 mm x 1.4 mm)
LANTERN POSITION | 11.2" H X 8" D X 5.5" W |
. . . . . . . . . . . . . . . . . . . . . . . . . . .(2.85 mm x 2.03 mm x 1.4 mm)
7