Vector VEC141 user manual Introduction, Features, Location Diagram, Operation, Recharging

NOTE: This unit is shipped in a partially charged state. Initial charge time is approximately 20-25 hours, 18 hours thereafter.

IMPORTANT SAFETY INSTRUCTIONS

WARNINGS: Contains non-spillable, sealed, lead-acid battery. Battery must be recycled or dis- posed of properly. For battery disposal information call toll-free 877-288-7722.

DO NOT dispose of batteries in fire, as this may result in an explosion. DO NOT open battery or short circuit, as this may cause the bat- tery to leak or get hot, causing personal injury.

Please read Instruction Manual completely for all safety and warning instructions.

WARNINGS: USE ONLY WITH CHARGERS PROVIDED WITH UNIT. DURING AC RECHARGE OR DC RECHARGE:

a)Never turn on while AC charging.

b)After recharge – disconnect cord and wait 5 minutes before use.

DO NOT OVERCHARGE:

a)AC recharge 18 hours.

b)DC recharge 5 hours maximum.

1.Do not substitute power cords or adapters. Only recharge with supplied AC and DC recharge adapters. Recharge adapters for this unit supply 12 volts DC. Do not recharge with adapters other than the ones supplied with this unit.

2.Do not submerge in water. This unit is not waterproof - it is weather resistant.

3.Do not overcharge battery.

4.Do not operate spotlight while AC recharging. This will prevent battery recharge and overheat the charging adapter.

5.Lens gets very hot when spotlight is operating. Do not touch lens - keep chil- dren away from spotlight. This is not a toy!

6.Keep combustibles away from spotlight lens - extreme heat can cause fires.

7.Keep sharp objects away from glass lens - it is breakable.

8.Do not drop or throw spotlight, it contains glass and a sealed lead acid bat- tery.

9.Dispose of unusable batteries in a responsible manner (see battery disposal section).

10.Make sure cords are protected from damage during recharge.

11.Do not crush, cut, pull or expose recharge adapter cords to extreme heat.

12.Keep recharge cords away from sharp edges. Position recharge cords so they do not become entangled or become a safety hazard.

1.INTRODUCTION

Congratulations on purchasing the Vector 2,000,000 Power Series Spotlight, an advanced design combination spotlight and area light. It instantly converts use from a powerful spotlight to a soft, long-lasting area light. It uses a powerful, proven-technol- ogy, rechargeable, non-spillable, sealed, lead-acid battery that allows for years of dependable use, recharge after recharge. The spotlight was designed from the ground up to be the most versatile and practical light for travel, camping, picnicking, tailgate parties and boating. This spotlight gives you the kind of light you need, when and where you need it.

SAVE THESE INSTRUCTIONS

2

Two recharge adapters are supplied with the spotlight. It is rechargeable from either a 12 volt DC accessory outlet, or from any 120 volt 60 Hz AC outlet. This permits recharge flexibility for use around home, business or in the field. 12 volt DC power is available from most vehicles, boats, jump starters and portable bat- tery packs. Vector has a variety of portable power products that would make ideal companions.

2.FEATURES

•High-intensity, ultra-white, 100-watt halogen bulb

•Corded/cordless, powerful Quartz Halogen Spotlight for use whenever and wherever you need light

•Provides up to 20 minutes of continuous light (when fully charged)

•Includes built-in area light located in grip

•Corded - plug into any 12 volt DC accessory outlet for extended use and charging

•Built-in utility work stand for garage, work bench and roadside repairs

•Take anywhere - use cordless or plug into 12 volt DC outlet

•Replace 12 volt, 3 amp, sealed, non spillable battery

•Powerful, prefocused, replaceable quartz halogen bulb in spotlight

•Recharge from home or vehicle (AC and DC adapters included)

3.LOCATION DIAGRAM

WORK STAND/CARRY HANDLE

(4 POSITIONS)

DC OPERATING AND

CHARGING PORT

LED CHARGING

INDICATORS

AC RECHARGE PORT

	SPOTLIGHT ON/OFF TRIGGER
FIGURE 1		TRIGGER LOCK
		SWITCH
	AREA LIGHT	AREA LIGHT ON/OFF BUTTON

4.OPERATION

A two-position switch (spotlight on/off) controls the operation of the main beam. The area light is controlled by a two-position button (area light on/off) is located on the side of the unit. The spotlight can be continuously lit for up to 20 minutes on a full battery charge. The area light can be lit for up to 12 hours on a full battery charge.

Figure 1 shows locations of the AC and DC charging ports, spotlight ON/OFF trigger, area light ON/OFF button, LED charging indicators, work stand/carry handle and trig- ger lock switch.

5.RECHARGING

AC and DC recharge requires use of these supplied recharge adapters. Do not charge spotlight using any other adapters (see Figures 2 and 3).

3