VEC258 Manual 3/03.qxp 1/23/07 5:18 PM Page 11
4.Push the pins the new bulb into the socket and make sure the bulb is fully inserted.
5.Replace the lens and bezel.
6.Tighten (clockwise) the bezel until it is snug.
7.Test the light for proper operation by turning it ON and then OFF.
8.3FLUORESCENT LAMP REPLACEMENT
The bulb type is a standard 4 watt F4T5/D fluorescent tube type. A replacement bulb can be purchased from local lighting, hardware or camping stores. The fluorescent lamp tube can be replaced after the front vertical lens is removed. The procedure follows:
1.Remove the battery pack or DC adapter. Using a small Phillips screwdriver, unscrew (counterclockwise) the small screw at the top of the lens.
2.Slide the lens down from the top of the unit. The lens will come off. Set the lens aside.
3.Remove the fluorescent tube by turning
4.Set the defective tube aside for proper disposal.
5.Put in a new tube, being careful to keep the bulb pins from bending.
6.Rotate the tube
7.Check the new tube to make sure it is secure in the sockets.
8.Replace the lens, and slide it towards the top of the unit. The screw holes should align.
9.Replace the small screw and carefully tighten with the Phillips screwdriver.
10.Follow local ordinances for fluorescent bulb disposal and discard the old bulb.
9.MAINTENANCE/REPLACEMENT PARTS
For replacement parts (batteries, DC power adapters, AC charging adapters, cables, etc.), contact Vector technical support: (954)
10.BATTERY REPLACEMENT
The battery in the battery pack should be replaced with a new one when the operating capacity is reduced to about one half or the ability to inflate one and one half average sized automobile tires. Make sure that the battery is fully charged before determining that the battery pack should be replaced. Contact Vector technical support and ask for part VEC194. This battery pack is also used with other Vector products that include portable inflators and spotlights. For more details, please contact our technical support department toll free at (866)
11.BATTERY DISPOSAL
Contains a
WARNINGS:
•Do not dispose of the battery pack in fire as this may result in an explosion.
•Before disposing of the battery pack, protect exposed terminals with
12.SPECIFICATIONS
FOR COMPRESSOR: |
|
Battery | .12 volt, 3 Amp Hour, |
Compressor | . . . . . . . . . . . . . . . . . . . . . . . . . . .260 PSI Maximum |
Weight | . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.82 lbs (.90 kg) |
Height w/battery . . . | . . . . . . . . . . . . . . . . . . . . . .11.25 inches (28.57 cm) |
Width | . . . . . . . . . . . . . . . . . . . . . . . .4.0 inches (10.16 cm) |
Length | . . . . . . . . . . . . . . . . . . . . . . . . . .7 inches (17.78 cm) |
LANTERN LIGHT:
Quartz Halogen Bulb . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15W, G4
Fluorescent Tube . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .F4T5/D
11 |
| 12 |
|
|
|