E Q
This button automatically EQs the subwoofer using a
NOTE: Each time the EQ feature is utilized, the EQ settings for the Optimum subwoofer are reset. If the microphone is not plugged in, the Optimum subwoofer will emit two sweep tones then cease the EQ operation. In this case, the previous EQ settings will be preserved.
P H A S E
These buttons allow you to optimize the subwoofer performance for the location and your listening position. Select the switch position at which you hear the most bass. The setting will be shown in the front panel display by “PH” followed by the phase setting selected — 0, 90, 180 or 270 degrees.
L I G H T
If you wish, you can deactivate the blue front panel display on your Optimum unit. To do this, press the LIGHT button on your remote. The display will turn off. It will turn on briefly to reflect any other setting changes while deactivated. To reactivate the display, press the LIGHT button again.
N I G H T
Night mode limits the maximum output of the subwoofer for later night listening or to be more considerate of close neighbors. Press the night button to turn the night mode feature on or off. Night mode, when active, is indicated by the reduced intensity of the display.
VOLUME CONTROL
This control allows you to balance the output from the subwoofer to the main speakers in your system. This control should be set to achieve similar volume level from both the main speakers and subwoofer. When pressing the volume up or down, the setting is shown in the front- mounted LED display as a number between 00 and 80.
NOTE: The volume can also be adjusted via the buttons on the back panel of the subwoofer. These buttons have the same effect as pressing the up and down volume buttons on your remote. The unit comes preset from the factory with the volume set at 30 out of a maximum setting of 80.
.w w w . v e l o d y n e . c o m | Optimum User’s Manual |
12 |