SC - 600 IW, SC - 600 IF/IC SUBWOOFERS
SC-600 IW (In-Wall):
-Two high excursion 6.5” active drivers, two 12.5” x 3” oval passive radiators with ribbed rubber surround
-
-2” dual layer inside/outside voice coil
-Frequency Response: 30 - 120Hz (+/- 3 dB)
-4 ohm impedance
SC-600 IF/IC (In-Floor/In-Ceiling):
-12” (9.7” piston diameter) subwoofer
-2.5” dual layer inside/outside voice coil
-Oversized spider for linearity at high excursion
-
-Frequency Response: 25 - 120Hz (+/- 3 dB)
-4 ohm impedance
S etup Checklist
Be sure to do the following to ensure the best performance from your subwoofer:
❑If possible, optimize the placement of the subwoofer(s) in the listening area. See page 10 of the User’s Manual.
❑Install and wire the subwoofer per the instructions on pages 3 - 8.
❑Select the proper model per the instructions on page 10.
❑Select the proper volume control. See page 4.
❑Be sure the low pass crossover is set correctly. See pages 8 - 9.
❑Be sure to equalize the subwoofer using the microphone and
❑Be sure to set the phase control on the remote. See page 11.
❑Select the correct preset for the source material. See page 13.
Your new Velodyne amplifier provides for a number of installation options. Read all the installation information below in order to determine which installation option is best for your system. Remember to perform all installation procedures with system power turned off.
.w w w . v e l o d y n e . c o m |
2 |
