Figure 1. Installation Using LFE |
|
Note: If not using an external crossover, you should use the | |
performance. When using a single channel input (such as a surround sound processor’s | |
subwoofer out or LFE), the auto on/off circuit sensitivity will be affected. When one input | |
channel is used instead of two, the unit will see lower signal levels present at the inputs. This | |
may cause the unit to turn off when listening at low volume levels. If this occurs, simply use a | |
“Y” adapter (available from most dealers) to allow your processor’s single sub line to be fed into | |
both L&R inputs. This will make the unit turn on at lower signal levels. |
|
.w w w . v e l o d y n e . c o m | VMS User’s Manual 5 |