READ ALL INSTRUCTIONS BEFORE USING
Important Safeguards
DANGER:
• Do not operate this lamp near a water source to avoid electrocution.
WARNING:
•Do NOT dismantle.
•Do not use with power supply voltage other than 120 VAC.
•Do not operate lamp in close proximity to flammable or combustible vapors, such as aerosol spray products, or where oxygen is being administered.
•Do not cut or shorten the power cord.
•The bulb in this product contains a trace amount of mercury, a chemical known to the state of California to cause birth defects or other reproductive harm. This substance may also cause injury if inhaled or ingested.
• For indoor use only.
CAUTION:
• Always unplug lamp before performing bulb replacement or installation.
• This lamp is not for use with light dimmers, timers, motion detectors, voltage transformers or extension cords.
• This product may cause interference with radios, cordless telephones or devices that use a wireless remote control, such as televisions. If interference occurs, move the product away from the device, plug the product or device into a different outlet or move the lamp out of the line of sight of the remote control receiver.
• Unplug lamp during lightning storms or when unused for extended periods of time.
• Do not lift the lamp by the gooseneck. The lamp should be lifted by the shaft.
• Be very careful not to pinch any part of the cord between any metal pieces.
• Do not use solvents or cleaners containing abrasives, or ammonia based cleaners on this product.
• All moisture should be properly wiped away and dried prior to restoring power.
• Do NOT use lubricating agent in assembly; please see troubleshooting section if you are having difficulty assembling your lamp.
• Disconnect lamp before performing alignment activity.
• Dispose of bulbs per local regulations. For more information on
• Care should be taken to prevent bulb breakage.
SAVE THESE INSTRUCTIONS
3
