Assembly Instructions
Read Instructions Carefully Before
Assembly:
1.Connect the two ends of the Power
Cord (between the Base and the Shaft) using the lock connectors.
2.Carefully tuck excess Power Cord into the Shaft.
WARNING: DO NOT CUT OR
SHORTEN THE POWER CORD.
3.Insert the Gooseneck and the Shaft into the Base.
4.Check direction of the lamp and the hole on the Base, then use a Phillips Head Screwdriver (not included) to tighten the screw into the hole.
CAUTION: BE VERY CAREFUL NOT TO PINCH ANY PART OF THE CORD BETWEEN ANY METAL PIECES.
MISE EN GARDE : PRENDRE
SOIN DE NE PAS PINCER LE
CORDON DANS DES PIÈCES MÉTALLIQUES.
Fig. 1
7
