Verilux VF02 manual Assembly Instructions - continued, connect only one way Fig

Assembly Instructions — continued

5.Attach the ballast to the power cord. Use care to align the 4-pin plug properly. DO NOT FORCE. The power cord is designed to

connect only one way (Fig. 5).

6.Plug the ballast into a standard 120V

50/60Hz outlet and turn the lamp on. The J green LED indicator (J) on center of the ballast will illuminate (Fig. 6). If not, please refer to the troubleshooting section of this manual (see page 11).

Note: Green LED indicator will not illuminate if lamp is turned off or bulb is removed.

WARNING: Do not block vents on the ballast. Vents are necessary for proper function of the ballast; blocking them may cause overheating of the ballast and increase the risk of fire.

ATTENTION!
ALWAYS lift your	DO NOT lift the lamp
lamp by the shaft	by the gooseneck

Fig. 5

Fig. 6

8