Verilux VF08 manual Assembly Instructions

ASSEMBLY INSTRUCTIONS

Before assembling, please review all instructions.

1.Carefully open box to avoid damaging the lamp when using a sharp knife.

2.Remove lamp and lay on floor.

3.Screw shaft (B) into the base (A) and hand tighten.

4.Next, screw shaft section (C) into shaft (B) and hand tighten.

5.Finally, screw the lamp upper assembly (D) into assembled lamp post (A,B,C) and tighten.

6.Using a Philips head screwdriver (included), carefully unscrew the three screws holding the Optix® Glare Control Filter in place. Remove filter and save for later.

7.Carefully insert the GU-24 Natural Spectrum® light bulb (included) into lamp by firmly holding bulb base and pushing down and rotating slightly in a clockwise direction to seat properly. Note: Make sure bulb is fully inserted into the socket. The bottom of the bulb base should touch the plastic housing of the lamp.

8.Place Optix® filter on lip of of inner shade cup, align holes and tighten first Philips head screw. DO NOT OVERTIGHTEN. Continue to insert and tighten the two remaining screws.

9.Plug lamp into an appropriate outlet and turn on the switch.

10.Adjust height for optimum illumination.

11.Do not use with an extension cord or on a circuit with a dimmer switch.

12.Save the packaging in case you need to send the lamp to Verilux for servicing.

3