Verilux VT01 manual General Precautions, Set-Upinstructions, Unpacking

GENERAL PRECAUTIONS

•Do not use with power supply voltage other than 120V AC

•Avoid placing the lamp in areas that are dusty, humid/moist, lack ventilation, or are subject to constant vibration.

•Not for use with light dimmers, timers, motion detectors, voltage transformers, or extension cords.

•Do NOT use lubricating agent in bulb assembly.

•Close supervision is recommended when this lamp is used by or near children, or others who may not understand the need for these precautions. Do not leave the lamp unattended during use.

This product may cause interference with radios, cordless telephones, or devices that use a wireless remote control, such as televisions.

This lamp has been tested and found to comply with Part 18 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This lamp generates, uses, and can radiate radio frequency energy and, if

not used in accordance with the instructions, may cause harmful interference to radio communications. If interference occurs try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the lamp and receiver.

•Connect the lamp into an outlet on a circuit different from that to which the receiver is connected.

•Move the lamp out of the line of sight of the remote control receiver.

•Consult the dealer or an experienced radio/TV technician for help.

Note: This product may cause interference to radio equipment and should not be installed near maritime safety communications equipment or other critical navigation or communication equipment operating between 0.45-30 MHz.

SET-UP INSTRUCTIONS

Unpacking

Please remove all packaging material. Check the carton for the items pictured below:

Lamp

DiffuserBulb

Selecting a location

•Place your Verilux® HappyLite® Mini Plus

Mood Enhancement System on a table or other flat surface.

•For best performance, place the lamp within two feet of you.

Note: Avoid placing this lamp in areas that are exposed to direct sunlight or close to heat-radiating products, such as heaters. Do not place the lamp on the top of appliances that radiate heat.

WARNING: DO NOT BLOCK VENTS

Vents are necessary for proper function of the electronic ballast; blocking them may cause overheating of the electronics and increase risk of fire.

4 5