INSTALLATION INSTRUCTIONS

Proper installation is the first step to operation. We recommend that your Pizza Table Refrigerator be installed by an authorized Victory Certified Installer.

Receiving Shipment

All units are performance tested and thoroughly inspected prior to shipment. Upon leaving the factory, all units are in perfect condition. Upon receipt, examine the exterior of the shipment packaging for any signs of rough handling. If the cabinet is damaged, it should be noted on the delivery slip or bill of lading and signed. A claim must be filed immediately against the carrier indicating the extent and estimated cost of damage incurred.

Uncrating

Refer to “VPT Uncrating & Caster Installation Instructions”

Locating Your New Pizza Table Refrigerator

Consider the following when selecting a location cabinet:

1.Clearance - (a) Pizza Table Refrigerators are spaced 2” (inches) off the wall by the drain line cover. There are no spacing requirements for the sides of the unit. (b) Pizza Table lids must have at least 1” (inch) clearance when fully opened to avoid any damage when or if the unit is under any type of covering.

2.Floor Load - The floor on which the cabinet will rest must be free of vibration and suitably strong enough to support the combined weights of the cabinet plus the maximum product load.

3.Ventilation - The air cooled, self-contained refrigeration system requires a sufficient amount of cool, clean air. Avoid placing the refrigerator cabinet near heat generating equipment such as ovens, ranges, heaters, fryers, steam kettles,

etc., and out of direct sunlight. Avoid locating the self-contained refrigerator cabinet in an unheated room, or where the room temperature may be below 65°F.

4.Ambient Temperature - Pizza Table Refrigerators are approved for operation under NSF-7 standard which is for operation in +86°F room temperature.

Installing Casters

Refer to “VPT Uncrating & Caster Installation Instructions”

Leveling

Refer to “VPT Uncrating & Caster Installation Instructions”

Cabinet Cleaning

Prior to placing your new Pizza Table Refrigerator and all shelves, pan dividers and food storage pans into operation, it is advisable that the interior be washed thoroughly with a mild detergent and water solution. Rinse with clear water and a sanitizing solution. Allow cabinet to air dry.

Installing Shelves

All cabinets with shelves are supplied with pilasters and shelf clip supports. Shelves are easily installed by inserting the shelf support clips into the pilasters so they fit tightly. Align the shelf so the smaller fill wires run from front to rear and rest the shelf on the clips.

Electric Supply

Wiring should be done by a qualified electrician in accordance with local electrical codes. A separate ground wire must be supplied for all installations. A properly wired refrigerator will assure proper operation. Electrical supply requirements are on the cabinet serial/data plate located on the upper left interior tank wall inside the cabinet. It is recommended that a direct, properly protected line of the proper size wire be installed from the main supply to your refrigerator. To assure that the correct voltage is being supplied, while the refrigerator is in operation take a voltage reading at the motor- compressor electrical connections, or as close to the motor-compressor as possible.

All refrigerator electrical systems are internally grounded.

Power Cord & Switch

The power cord for the Pizza Table Refrigerator is shipped inside the refrigeration compartment.

1.Remove the rear refrigeration cover. (See Figure 1)

2.Remove the two 1/4” hex head shipping bolts at the rear of the condensing unit base. With these shipping bolts removed, the condensing unit is serviceable from the front of the Pizza Table Refrigerator. (See Figure 2)

3.Feed the power cord plug thru the round opening and reinstall the rear refrigeration cover to provide power to the

Pizza Table Refrigerator.

1