Vidikron 80 Connector Panel

RS-232C DVI

SVCSYNC

OUT

1. [SYNC OUT] Terminal

This terminal is intended for servicing purposes. Do not use it.

Using it may cause an error or malfunction of the unit.

2. [SERVICE] Terminal

This terminal is intended for servicing purposes. Do not use it.

Using it may cause an error and malfunction of the unit.

3. [RS-232C] Terminal (D-sub 9 Pin)

This is the RS-232C interface-speciﬁ c terminal. This unit can be

controlled by a computer connected externally. (See page 18)

• For details, please check with your authorized dealer.

4. [DVI] Terminal (DVI-D 24 Pin)

This is an input terminal for video signals.

Connect this to the VDP-80 dedicated digital video processor.

(See page 18)

Connector Panel

Contents

Main Table of Contents Accessories Introduction Safety Precautions NOTICE (For USA) IMPORTANT INFORMATION IMPORTANT SAFEGUARDS Page Power Connection Safety Precautions (continued) About Burning-in of D-ILA Device Standard for gauging replacement time of components Viewing Conditions (Brightness of Room) Environment of Use Maintenance Procedures Two Year Limited Warranty Warranty For Projectors, Video Processors and Controllers Page Controls and Features Projector Chassis Cover Connector Panel Control Panel on the Projector Controls and Features (continued) Indicator Display on the Control Panel After the cool down process is completed, the unit will automati- is to prevent damage and deformation that heat from the heated Remote Control Controls and Features (continued) Installation Environment Precaution for Usage Precautions for Installation Installing the Projector Minimum Space Required Projector and Screen Installation Side View Top View Installing the Projector (continued) Mounting the Unit on a Ceiling Screen Size and Projection Distance Throw Distance Chart Page Connecting to Devices Connecting to the VDP-80 digital video processor Control from an external automation device Connecting to Various Devices 1. Connecting the Power Cord (supplied) Connect the supplied power cord to the power input terminal of the projector. Connecting to Various Devices (continued) 2. Basic Operation Turning on the power Adjusting Zoom Adjusting Focus Turning on the power Hiding the image temporarily Basic Operation (continued) Adjustments and Settings Using Menus The menus displayed on the screen are used to perform adjustments and settings for this unit. *1 Press the [ENTER] button to switch to the test pattern image. Projector Opt Menu E.g.: OSD Position Settings Menu Menu Operation Buttons Main unit Adjustments and Settings Using Menus (continued) Menu Remote control unit Procedures for Menu Operation Adjustments and Settings Using Menus (continued) 1 Picture adjust Menu 2 Projector Opt Menu 4 Information Menu 3 Options Menu Screen Blanking V Shift Setting Replacing the Lamp (For service personnel only) Lamp and Lamp Usage Time About Lamp Replacement Resetting Lamp Time Page What to do when these messages are displayed Warning Indication About warning indicators Actions to be taken upon warning indications Please follow the procedures below. Troubleshooting Before sending the unit to your Vidikron dealer for repair, check the following points. Terminal Description Pin Arrangement DVI Terminal RS-232C Terminal RS-232C External Control [ 2. Command Format ] Terminal Description (continued) Speci cations