Page 17
Electrical Connection
Please follow the instruction below to properly connect the LCD monitor to
external electrical source.
1. Connect the female-end of the power cable to the transformer. Connect the
male-end of the power cable to the wall outlet or extension cable.
2. Connect the cable from the other end of the transformer to the LCD monitor
located at the back near the VGA signal cable.
Signal Connection
1. Power off both the LCD monitor and PC system before connecting them.
2. Take out the VGA cable from the box, then connect it to the signal connector at
the back of the LCD monitor.
3. Connect the other end to the VGA connector on the back of the PC system.
4. Please make sure the connections to both the PC system unit and the LCD
monitor is strong and secure. Please don’t forget to tighten the screws on each
connector end.
5. Now turn on both the PC system unit and the LCD monitor.
6. After you finish setting up the LCD monitor, please set the refresh rate to 75Hz.
7. After setting up the LCD monitor, please perform Auto Adjust in OSD so that
the LCD monitor will be automatically set to optimal color display each time.
* Please note: When you disconnect any power cable or signal cable, please do not
pull the cable by grabbing the cable body. Please grab the cable connector itself
whenever you try to pull the cable during disconnect.