8.As shown in the figure, hold the new lamp first and align the lamp with the compartment in the projector, and then insert the lamp all the way into the projector.
9.Tighten the screw that secures the lamp.
Loose screw may cause a bad connection, which could result in malfunction.
Do not over tighten the screw.
10.Connect the lamp connector to the projector.
11.Place the lamp cords back to the slots.
12.Replace the lamp cover on the projector.
13.Tighten the screws that secure the lamp cover.
Loose screw may cause a bad connection, which could result in malfunction.
Do not over tighten the screws.
14.Restart the projector.
Do not turn the power on with the lamp cover removed.
15.Resetting the lamp timer
Do not reset if the lamp is not replaced as this could cause damage.
i.Go to the SYSTEM SETUP: Advanced > Lamp Settings menu. Press MODE/ENTER.
ii.The Lamp Settings page displays. Highlight Reset Lamp Timer.
iii.A warning message displays asking if you want to reset the lamp timer. Highlight Reset and press MODE/ENTER. The lamp time will be reset to '0'.
Notice
Reset lamp timer?
Reset Cancel
ViewSonic | 41 | PJ513D/PJ513DB |
