General Use
Base Installation
In the Photo Frame back, pull the stand out of the slot.
After a “stuck” sound, lift the stand by turning 45°. Then the installation is complete.
Operation
Before you can use the picture frame, it has to be connected to the power supply. Plug the connection cable of the power adapter into the respective plug of the picture frame and plug the power adapter into a wall outlet .
Power on/off your picture frame
To power on the photo frame, please press the Power button longer than 3 seconds. To power off the photo frame, please press the Power button again.
The green indicator light will light up and the device will show the ViewSonic screen.
Again press the Power power button on the side of Photo Frame, or press on the remote control. The indicator light will turn off.
[Note] The Power key on remote controller can switch the set between On and Standby mode only when the Photo frame is activated by the Power button at the side of frame.
Insert memory card and USB drive
Push the memory card (not included) gently into the respective card slot until it stops. When inserting a SD/ SDHC/MMC card, make sure that the contacts show to the back. You can also insert USB drive into USB slot instead.
ViewSonic | 4 | 3DPF8 |
