Viking DGWH Installation Requirements, Ventilation, Built-In Classic Chimney Glass Wall Hood

VENTILATION

Built-In Classic Chimney Glass Wall Hood

Installation Requirements

Proper installation/ductingis extremely important to ensure maximum performance.Use a qualifiedand trained installer.

DUCTING

•450 CFM interior (blower included)

•Check with a qualified and trained installer for local codes and makeup air requirements, if any.

•Max. duct run length—50’ (152.4 m)

o Duct run length is for general reference only; for longer duct runs, increase duct size and contact a qualified and trained installer.

o Straight runs and gradual turns are best; for example, each 90” elbow is equivalent to 5’ – 10’ (1.52 – 3.05 cm) of straight run.

DGWH Designer

Chimney Glass Wall Hood

UTILITY REQ UIREMENTS

•6” round duct

o Never use flexible duct; it creates back pressure/air turbulence and greatly reduces performance.

GAS

Not applicable

ELECTRICAL

• Hardwire direct with two-wire with ground

•120 VAC/60 Hz

•Max. amp usage—3.13

PLUMBING

Not applicable

Note: All CFMs are based on tests with 0.1 static pressure. Without applying static pressure (some brands do not), CFM could be greatly overstated.

Model

DGWH3646

Interior Ventilator Kits

450 CFM Standard

Interior Duct Size

6” (15.2 cm)

Interior Max. Amps

3.13

PLANNING	AND	DESIGN	GUIDE	R EL EA S E D 1 1/ 1 1 / 0 8
VIKI NGR ANG	E.C OM	• 1-8 88-	V IKI NG1	© 2 0 0 8 V R C — INFORMATION SUBJECT TO CHANGE