GENERAL INFORMATION
Unpack
1.Remove banding from bottom of carton. Lift carton up and off of the unit.
2.Remove all tape and packaging material from the outside and inside of the cabinet.
3.Keep all carton packaging until your refrigerated beverage center has been thoroughly inspected and found to be in good condition.
AREA REQUIREMENTS
Units Certified for Indoor Use - (black outer cabinet)
MUST BE INSTALLED IN AN AREA PROTECTED FROM THE ELEMENTS, SUCH AS W IND, RAIN, WATER (SPRAY OR DRIP).
1.Place unit so the front side will be completely unobstructed to provide proper air flow. The unit may be closed in on the top and three sides, but the front MUST BE unobstructed for air circulation and proper operation. Installation should be such that the cabinet can be moved for servicing if necessary.
2.Unit should be in a well ventilated area with temperature above 550F (130C) and below 1100F (430C). Best results are obtained at temperatures between 650F (180C) and 800F (270C) for
3.Provisions for electricity should be determined before placing unit in proper place.
Units Certified for Outdoor Use - (stainless steel outer cabinet)
1.Place unit so the front side will be completely unobstructed to provide proper air flow. The unit may be closed in on the top and three sides, but the front MUST BE unobstructed for air circulation and proper operation. Installation should be such that the cabinet can be moved for servicing if necessary.
2.Unit should be in a well ventilated area with temperature above 400F (4.40C) and below 1100F (430C). Best results are obtained at temperatures between 600F (160C) and 1000F (380C).
3.Provisions for electricity should be determined before placing unit in proper place.
REVERSIBLE DOOR
Professional Series
(Glass Door Units Only)
You can change the door swing from right toeftl hinge veryeasily.
1.Simply unscrew the top hinge door swing pin with an 1/8” allen drive unit and lift door off of thebottom hinge bracket. Flip the door,remove the light switch activator and replace the light switch activator on the other end of the door.
2.Remove the door swing pin from bottom right hinge. Move the bottom, right hinge bracket to the upper, left side of the cabinet and fasten it in place with its original mounting screws.
3.Install the hinge door swing pin intothe top right hinge bracket and move the bracket to the lower left side of the cabinet. Fasten it in place with its original screws.
4.Place the plastic washer over the bottom door swing pin on the top surface of the bottom, left hinge.
5.Position the door on the bottom,left hinge pin and push the door underthe top, left hinge.
6.
7.Reposition thelogo. Your installation is now complete.
Door Swing Pin (Flush head, 1/8” allen drive)
Top Hinge
Bracket
Bottom Hinge
Bracket
Light Switch Activator |
| Door Swing Pin |
|
| (Round head, Phillips) |
|
| |
|
|
|
4