Replacing Oven Lights, To stop the Self-Clean cycle

Self-Clean Cycle

To start the Self-Clean cycle:

1.	Close the door completely.
2.	Turn the oven selector knob clockwise to the “SELF CLEAN” mode.
3.	Turn the temperature control knobpast the clean setting until the
	knob stops. At this time, the clean indicator light will come on. Within
	30 seconds the automatic door latch engages and the oven indicator
	light comes on. The oven indicator light will remain on until the oven
	reaches the self-clean temperature and will then cycle on and off
	during the self-clean cycle. When the oven reaches the elevated
	temperature needed for self-clean, the door lock indicator light
	comes on.

Replacing Oven Lights

WARNING

ELECTRICAL SHOCK HAZARD

Disconnect the electric power at the main fuse or circuit breaker before replacing bulb.

CAUTION

To avoid risk of personal injury, DO NOT touch bulb with bare hands. Clean off any signs of oil from the bulb and handle with a soft cloth.

4. The door lock indicator light will remain on until the self-clean is

completed or interrupted and the oven temperature drops to a safe

temperature. A complete cycle is approximately 3-1/2 hours with an

additional 30 minutes needed for the oven to cool down enough for

the door latch to disengage.

Note: A fan noise will be heard during the self-clean cycle and will

continue to run for the 3-1/2 hour duration of the self-clean cycle.

1.Unsnap glass light cover using a screwdriver in the access groove.

2.Firmly grasp light bulb and pull out.

glass light

cover

access groove

5. When the cycle is completed, turn both the oven selector and

temperature control knob to the “OFF” position. When the oven has

completely cooled, open door and remove any ash from the oven

surfaces with a damp cloth.

To stop the Self-Clean cycle:

To cancel or interrupt the self-cleaning cycle, turn both the temperature control knob and the oven function selector knob to “OFF”. When the oven temperature dropsto a safe temperature, the automatic door latch will release and the oven door can be opened. When the oven has completely cooled, remove any ash from the oven surfaces with a damp sponge or cloth.

3.Replace with halogen bulb using volt and wattage requirements listed on glass cover.

4.Replace the light cover by snapping glass cover onto metal box.

5.Reconnect power at the main fuse or circuit breaker.

light bulb

Viking F20654 Replacing Oven Lights, To start the Self-Clean cycle, To stop the Self-Clean cycle

Models: F20654