![](/images/new-backgrounds/1011872/1187215x1.webp)
VIKING RANGE, LLC | Downdraft Ventilators |
MOUNT THE UNIT
All Units
1.Set downdraft into opening. Extend leveling brackets to floor of cabinet so downdraft sits straight. (Note: Leveling brackets can be removed and
2.Secure the downdraft to the countertop as follows: Hold the downdraft against the back of countertop
3.Screw leveling brackets to bottom of cabinet. Tighten screws holding leveling bracket to unit on each side.
INSTALL DUCTWORK
MOUNTING SCREWS
LEVELING BRACKET -
FLANGE FACING OUT
LEVELING BRACKET -
FLANGE FACING IN
| Interior Blower Installation |
|
|
| Exterior Blower Installation |
| |||||
|
|
|
|
| |||||||
|
|
| ! |
|
|
|
|
|
| ||
|
| CAUTION: |
|
| |||||||
|
|
|
|
| BEFORE CUTTING HOLE IN |
|
| ||||
|
|
|
|
| CABINET FOR DUCTWORK, |
|
| ||||
|
|
|
|
| check for interference with floor |
|
| ||||
|
|
| |||||||||
|
|
|
|
| joists, wall studs, electrical |
|
| ||||
|
|
| |||||||||
|
|
|
|
| wiring, or plumbing. |
|
|
BLOWER
TO 6" RD.
COLLARTRANSITION
SCREWS
6" RD. ELBOW & DUCTWORK
1.Cut hole in cabinet as well as holes in wall or floor as necessary.
2.Mount the roof or wall cap and work back towards the cabinet, attaching all ductwork, elbows and transitions as previously planned. Tape all ductwork connections to make them secure and air tight.
3.Connect ductwork (and transition, if required) to downdraft. If necessary, LOOSEN nuts and screws that hold the blower in place, and slide blower left or right to meet ductwork.
Note: A
ELBOW
10" ROUND DUCT
ELBOW
1.Cut hole in cabinet as well as holes in wall or floor as necessary.
2.Mount the exterior blower and work back towards the cabinet, attaching all ductwork, elbows and transitions as previously planned. Tape all ductwork connections to make them secure and air tight.
3.Connect ductwork to downdraft. If necessary, LOOSEN nuts and screws that hold remote blower adapter plate in place, and slide outlet assembly left or right to meet ductwork.
8