Disassemble/Assemble instructions
FOR YOUR PERSONAL WINECELLAR
BEFORE PROCEEDING, PLEASE READ ALL INSTRUCTIONS FIRST!
The tools required for disassembly and reassembly of your custom Winecellar are as follows:
A)7/16 Wrench
B)Phillips Head Screwdriver
C)Metric 4mm Hex Wrench
D)1/4” Nut Driver
You will need a clean level area. It will be necessary for 2 or 3 people to help in disassembly to complete the following instructions:
1.Remove shipping carton and packing material with exception to pallet. Open door and remove the plastic bag containing four or six casters depending on the size of unit.
2.Place the cardboard on ground behind winecellar.
3.With the 7/16” wrench, remove the two baits at the top of cooling unit. Carefully slide the unit out and place it on the ground out of the way in an upright position, being careful not to damage the insulated bottom.
4.If you have a model 700, remove the middle bar by removing center screw in back brace, then remove screws on top and bottom of middle bar.
5.Carefully remove the screws that are on the cabinet side of the hinge making sure someone is holding the door while screws are being removed. Place the door on cardboard to the side of winecellar.
6.With the Phillips Head Screwdriver or 1/4” Nut Driver carefully remove the screws holding the bottle racks, be sure to save the screws which are located in the top back of rack. Remove entire rack. (Standard cellar trellis racks)
Note: Models with horizontal support bar (single door 440 and single door 400), the bar must be removed prior to removing rack.
Removal of
