REVERSAL OF DOOR SWING

The door of the wine cellar could be opened either from the left or right side. The wine cellar, factory is installed from the left side.

If you want to reverse the open direction of door, please do as follows:

1.Disconnect the power, take out all the wines and lay the wine cellar back on the ground. Please remember when finished reversing the door, not to power up the unit for 24 hours to allow the coolants to settle in the compressor.

2.Remove top hinge cover. Use the special screw driver to remove the three screws on the top hinge, then lift up the door to take the door off.

3.Remove the support wheel on the left bracket.

4.Unscrew the two screws and remove the grill.

5.Use the special screw driver to unscrew the six screws on the right downward door axis and left bracket.

5.Install the right bracket and left downward door axis.

6.Remove the door handle, and fix it on the right of the door, please do as following:

a. Pull the gasket with hand, then you can see four screws (Two screws are on the upper of door, and other two screws are on the lower of door).

b.Remove these fixing four screws on the door handle.

c.Remove the handle, and fix it on the other side of the door. Screw four screws on the other side of door. Then embed the gasket to the

door.

8.Reinstall the door.

9.Install the top hinge on the other side.

10.Screw back in place the top hinge cover, grill and screw covers.

11.Install the support wheel on the right bracket.

12.You now have the door fully installed on your desired side.

1 7 6 2 1 S o u t h S u s a n n a R o a d ,

R a n c h o D o m i n g u e z ,

C a l i f o r n i a 9 0 2 2 1

10

i n f o @ v i n o t e m p . c o m

- F a x 3 1 0 . 8 8 6 . 3 3 1 0

800 . 777 . 8466

Page 10
Image 10
Vinotemp VT-50SBW instruction manual Reversal of Door Swing