Fig. 2.3 TOP EXHAUST GASKET
(LOCATED ON THE COOLING UNIT)
•Cut a rectangular inside opening at the rear of the cabinet with the 1/4” clearance inwards to the width and height of the cooling unit. By not going through, leave 1/2” lip inside at the wall to place the gaskets (see Fig. 2.2).
•If top exhaust, cut another rectangular opening at the top of the cabinet to the length and width of the top exhaust (see Fig.2.2).
•Make 2 holes at the ceiling to install the 1/4 inside diameter wood thread inserts (see Fig.2.2).
•Place the gaskets (1) on the gasket lips (see Fig 2.1).
•If top exhaust, place another gaskets along the top exhaust at the top of the cooling unit (see Fig.2.3).
•Place the cooling unit to a flat and stable place.
•Then move it on the top of the wine rack temporally.
•Move the cooling unit towards the mounting sides and push to press the gaskets.
•Fasten the 2 brackets and use 7/16” wrench to tighten the 2 screws (see Fig 2.1).
•If top exhaust, install another top exhaust grille at the top of the cabinet.
•Plug the cooling unit in receptacle.
•Plug the wine cabinet.
NOTE: DO NOT INSTALL ANY DUCTS ONTO THE SUPPLY, INTAKE ANY EXHAUST.
3.Electrical Cord
•Because of potential safety hazards under a certain condition, we strongly recommend against the use of an extension cord. However, if you still elect to use an extension cord, it is absolutely necessary that it will be a UL LISTED
-7 -
