Viper FANG 20-EU Scrapping, Remarks, English, 82089E12009-04A, SCRUBBERS FANG20-EU / FANG20T-EU

ENGLISH USER MANUAL

SCRAPPING

Have the machine scrapped by a qualified scrapper.

Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the Law in force:

–Batteries

–Brushes/pads

–Plastic hoses and components

–Electrical and electronic components (*)

(*)Refer to the nearest Viper Center especially when scrapping electrical and electronic components.

NOTE

If the machine has an optional battery charger installed, the machine cannot operate if the charger is not on board. In case of battery charger malfunction, contact an authorised Service Center.

For further information refer to the Service Manual, available at any Viper Service Center.

REMARKS

CAUTION!

The use of non-genuine spare parts, accessories, Batteries and chargers can impair the safety of the appliance. Only use spare parts and accessories from VIPER and use batteries and chargers which VIPER recommend. When using non-certified and not recommended batteries and chargers, VIPER will not cover the cost of damages (warranty) caused of this.

The following are batteries installing instruction:

a)Batteries (WET or GEL) already installed and ready to be used

1.Check that the batteries are connected to the machine with the charger plug.

2.Insert the ignition key (28) and turn it to "on".

If the green warning light (3a) turns on, the batteries are ready to be used.

If the yellow or red warning light (3) turns on, the batteri es must be charged (see the procedure in Maintenance chapter).

b)Batteries (WET) installed on the machine, but without electrolyte

1.Open the cover (22) and check that the recovery water tank (21) is empty, otherwise empty it with the drain hose (6).

2.Carefully lift the tank (21).

WARNING!

Pay attention when using sulphuric acid, as it is corrosive. If it comes in contact with skin or eyes, rinse thoroughly with water and consult a physician.

Batteries have to be filled in a well-ventilated area. Wear protective gloves.

3.Fill up the battery cells with sulphuric acid for batteries (density 1.27 to 1.29 kg at 25°C) in accordance with the instructions shown in the Battery Manual. The correct quantity of sulphuric acid is shown in the Battery Manual.

4.To avoid damaging the floor, dry with a cloth both acid and water on the top of the batteries after charging.

5.Let the batteries rest and fill in with sulphuric acid in accordance with the instructions shown in the Battery Manual.

6.Charge the batteries (see the procedure in Maintenance chapter).

Viper Europe

Sognevej 25 DK-2605 Brondby Denmark

82089E(1)2009-04A SCRUBBERS FANG20-EU / FANG20T-EU

21