S T E P 2 | BLUE BAG |
Wire Harness
Heart Rate |
|
Wires | Console Mast |
|
•Slide the console mast boot onto the console mast.
•Unfold the wire harness located in the console mast frame bracket. Connect it to the wire tie coming from the bottom of the console mast. Pull the wire tie and wire harness up through the top of the console mast while simultaneously sliding the mast into the frame bracket.
•Secure the mast to the frame using six lock washers (M8) and six screws (M8x15L). Tighten with the 5mm Allen wrench. Place the seventh screw (M8x15L) in the rear of the frame bracket and tighten until snug.
•Slide the console mast boot down and snap it into place on the side cover.
•Remove the nuts (M8) from the bottom of the seat. Attach the seat to the seat post with the nuts you just removed. Tighten with the 15mm wrench.
S T E P 2
Console Mast
Boot
Frame
Bracket
6
