S T E P 1 ORANGE BAG
Seat Frame
Seat Rail
Rail Support
C O R R E C T I N C O R R E C T
•Attach the rear support to the seat rail with four screws (M8x15) and four lock washers (M8). Tighten with the 5mm
•Slide the seat frame onto the seat rail. Make sure the flat side of the clamp block rests against the bottom of the seat rail.
•Insert the heart rate wires located under the seat frame through the hole on the bottom of the seat rail and push them toward the front of the rail. Take the end of the heart rate wires that runs through the seat rail and insert them through the hole in the bracket at the end of the rail. Snap the wire grip around the end of the heart rate wires and slide it into place on the bracket.
•Attach the rubber stopper to the bot- tom of the seat rail with the (M5x10) screw.
S T E P 1
Wire Grip
5
