Vision Fitness R2000, R2100 manual E P 4 Green BAG, Waterbottle Bracket Mast Cover 0 0

S T E P 4 GREEN BAG

Console Mast

Mounting

Bracket

R 2 1 0 0

S T E P 4

Waterbottle

Bracket

Mast Cover

R 2 0 0 0

•Slide the mast cover onto the console mast.

•With the included wire tie, pull the console cable, or sensor wire, and heart rate wires, through the console mast. Place the console mast into the console mast mounting bracket. Secure the mast to the bracket with five screws (M8x15L) and four lock washers (M8) and tighten with the 5mm T-shaped wrench. NOTE: The screw facing the seat does not use a lock washer. Tighten this screw until snug. Slide the console mast cover down over the screw heads.

•R2000 ONLY: Turn the tension knob to level 16. Direct the cable on the tension knob through the tension knob bracket. Attach the cable to the tension cable located in the console mast. Secure the tension knob to the console mast with the washer (M5) and screw (M5x65L). Tighten with the screwdriver.

•Remove the four screws from the back of the console. Plug the wire harness and heart rate wires into the console. Mount the console onto the console mast with the four screws.

•R2000 ONLY: Insert the two AA bat- teries into the console.

•Remove the two M5x15L Screws from the water bottle cage holes on the console mast.

•R2000 ONLY: Secure the water bottle bracket to the console mast with the 4mm L-shaped wrench and two cap screws (M5x35L). Attach the water bottle cage to the bracket with two screws (M5x15L) using the screwdriver. Insert the water bottle into the cage.

•R2100 ONLY: Attach the water bottle cage to the console mast with two screws (M5x15L) using the screwdriver. Insert the water bottle into the cage.

8