S T E P 1 O R A N G E B A G
•Install the rear foot with the four lock washers (M8), two inside screws (M8x65L), and two outside screws (M8x20L). Tighten with the 5MM Allen wrench.
S T E P 2
5
S T E P 1
S T E P 2 | B L U E B A G |
•Slide the rubber boot onto the console mast.
•Locate the bundle of wires that comes from the console mast frame bracket. Wrap the wire tie coming from the bottom of the console mast around the bundle of wires. Pull the wire tie with the bundle of wires up through the top of the console mast while simultaneously sliding the mast into the frame bracket.
•Secure the console mast to the frame bracket with six lock washers (M8) and six screws (M8x15L). Tighten with the 5MM Allen wrench. Place the seventh screw (M8x15L) in the rear of the frame bracket and
tighten until snug.
•Slide the console mast boot down and snap it into place on the side cover.
•Remove the screws located half way up the console mast with the Phillips screwdriver. Attach the water bottle bracket to the console mast with these two screws. Insert the water bottle.
