Vita-Mix High-Performance Commercial Blenders 20 or 45 Second Timer Model, Two-Step Timer Model

NOTE: Blenders come with several different control options. Please be sure you are following the instructions for your blender model.

20 or 45 Second Timer Model

ON/OFF switch. Up for ON. Down for OFF. All times are at HIGH speed. During operation, you may interrupt timer by turning power

ON

OFF

START

TIMER

:25	:30
:20	ON
:15
:10	OFF

START/STOP

TIMER

Note on Two-Step Timers: Stop mid cycle with START/STOP switch, not the power switch. If the power switch

Two-Step Timer Model

ON/OFF switch. Up for ON. Down for OFF. All times are total times. During operation, you may interrupt timer by pressing START/STOP switch.

TIMER DIAL. Allows user to select a number of timed settings. Increments on timer are approximate seconds. Timer is activated only when the power switch is ON. Blender will shut off automatically at the end of the pre-set time.

switch OFF.

TIMER dial. Allows user to select a number of timed settings. Increments on timer are approximate seconds. Timer is activated only when the power switch is ON. Blender will shut off automatically at the end of the pre-set time.

START TIMER switch. This is a lighted switch. When light is lit power is on. Depress START TIMER switch to activate timer setting.

was used, wait 30 seconds for power to recycle and the timer to reset before resuming operation.

ON II,I

II	HIGH
	OFF
I	LOW

START TIMER switch. This is a lighted switch. When light is lit power is on. Depress START TIMER switch to activate timer setting and again to stop midcycle.

Two-Speed Model

ON/OFF switch. Up for ON. Down for OFF.

HIGH/LOW switch. Up for HIGH. Down for LOW.

Bar Boss Timer Model

ON/OFF switch. Located on the front of the machine below the switch panel, controls the power to the machine. With the machine plugged in, switch the machine to ON to ready the machine for blending. Shut OFF power switch at night or whenever the machine will be left unattended.

START TIMER switch. This is a lighted switch. When light is lit power is on. Depress START

Note on Bar Boss Timers: Stop mid cycle with START/STOP switch, not the ON/OFF switch. If the ON/OFF switch was used, wait 30 seconds for

		5	6
	4		7		II,I
				ON
	H			8
II	HIG
	3
	2			9
				OFF
	LE	1	10
I	VARIAB

Variable Speed Model

ON/OFF switch. Up for ON; down for OFF.

HIGH/VARIABLE switch. HIGH overrides the VARIABLE SPEED dial and is the fastest speed available. VARIABLE speed is required to use the VARIABLE SPEED dial.

TIMER switch to activate timer setting and again to stop midcycle.

During operation, you may interrupt timer by pressing START/STOP switch.

TIMER DIAL. Allows user to select a number of timed settings. Increments on timer are approximate seconds. Timer is activated only

power to recycle and the timer to reset before resuming operation.

VARIABLE SPEED dial. Allows user to select continuously variable motor speeds ranging from 1,000 rpm to 24,000 rpm. Active only when HIGH/VARIABLE switch is set on VARIABLE position.

NOTE: Switches will become sticky from use. Use a wet cloth or sponge to flush and clean in the groove around the water-shielded switches. You may also lightly spray the surface around the switches with an all purpose cleaner such as Cinch® or 409® and work the switches back and forth a few times to loosen any dried residue under switch. Leaving switches sticky will damage or burn out the switches.

4

when the power switch is ON. Blender will shut off automatically at the end of the pre-set time.

PULSE switch. Pulse button can only be used when the power switch is ON. The PULSE switch can be used to quickly refresh product in the container by depressing the switch and holding down as long as needed.

5