Appendix
A. Troubleshooting
Status LED
The following table lists the LED patterns in general.
Condition | LED color |
Loading system after power on | Blink green and orange (twice) |
|
|
During booting procedure | Non light |
|
|
Detecting and setting network | Steady orange till IP address is confirmed |
|
|
After network is setup (system up) | Blink orange and red |
|
|
During the upgrade firmware process | Rapidly blink orange till firmware is |
| upgraded |
|
|
Reset and restore
There is a button in the back of the Network Camera. It is used to reset the system or restore the factory default settings. Sometimes resetting the system sets the system back to normal state. If the system problems remain after reset, restore the factory settings and install again.
RESET: Click on the button.
RESTORE:
1.Press on the reset button continuously until the status LED rapidly blinks orange. It takes about 30 seconds.
2.Upon successful restore, the status LED will blink orange and red.
Restoring the factory defaults will erase any previous settings. Reset or restore the system after power on.
- 61 -
www.vivotek.com
T: 886-2-82455282
F:
