VIVOTEK
User's Manual - 11
1. Disassemble the components of the waterproof connector into part (A) ~ (E) as shown
above.
2. Open the rear cover of the Network Camera.
3. Remove the rubber stopper from the bottom of the Network Camera and secure the
screw nut (A) tightly.
4. If you need extra power for external devices, please feed the power cable through the
wall mount bracket and the waterproof connector (E --> D --> B --> A) as the illustration
shown below. Then connect the power cord to the socket. Note: There are 7 holes on
the seal (B), and the widest hole with a crack on the side is specic for power cord.
5. If you have external devices such as sensors and alarms, feed the cables through the
wall mount bracket and the waterproof connector (E --> D --> B --> A) as the illustration
shown below. Then refer to the pin denition to connect them to the general I/O terminal
block. Note: The recommended cable gauge is 2.0 ~ 2.8 mm.
6. Push the seal (B) into the housing (D).
7. Insert the seals (C) into the empty holes on the seal (B) to avoid moisture.
8. Secure the sealing nut (E) tightly.
Assembling Steps
5
4
8
(E)
3
4
(E)
(D)
(B)
(A) 7
6(C)
(B)
(D)
9. Open the aluminum foil vacuum bag
and take out the desiccant bag. Attach
the desiccant bag to the inner side of the
rear cover, to under the insulation pad,
and then tighten the rear cover. (Please
replace the desiccant bag with a new one
whenever you open the rear cover.)
9-2
9-2
9-1