VIZIO 60HZ E SERIES User Manual
28
Version 3/17/2010 www.VIZIO.com
1. Press INPUT on the remote or on the side of your HDTV
to select the input source that matches the connection
you made on the back of your HDTV. A repeated press
of INPUT cycles you through the options.
2. Turn on your component (cable box, VCR, satellite
receiver, DVD player, etc.). You should see a picture on
your HDTV after few seconds. If you do not see a
picture, press INPUT again to select next signal input.
Repeat the INPUT pressing until the correct input is
found.
Note: If the selected input is RF, your HDTV needs to be on
either channel 3 or 4 to match the channel on the VCR,
cable box, external TV tuner or satellite receiver. Refer to
the User’s Manual of your equipment for details. This type of
configuration is most common with older SD (480i) receivers.
Note: Your HDTV will display the television station or program selected by the cable box, VCR,
external tuner, or satellite receiver. Use the remote control that came with that component to
change programs or channels. If the service being used is the one which setup includes a box
with two outputs for two different (distant) rooms, then scanning channels will help you to find the
signal. Be aware that the channel to be selected varies from provider to provider. You may have to
call your provider to get the specific channel when using your HDTV. Some examples of these
channels are 105, 106, 115, and 116.