Vizio E280i-B1 user manual

The buttons on the remote aren’t working.

•The Red and Yellow colored buttons below the V button do not work with this television.

•Ensure you are only pressing one button at a time.

•Point the remote directly at the TV when pressing a button.

•If the base is intalled, the remote must be at or above the level of the base.

•Replace the remote batteries with new ones. See Replacing the Batteries on page 11.

The image quality is not good.

•For the best image quality, view high-definition programs using digital sources. Connect your devices with HDMI cables.

•If you are using an antenna, the signal strength of the channel may be low. Ensure your antenna is connected securely to the TV and move the antenna around the room or close to a window for the best signal.

The picture is distorted.

•Nearby electrical devices may be interfering with the TV. Move the TV away from electrical appliances, cars, and fluorescent lights.

•Ensure all cables are securely attached.

The displayed image does not cover the entire screen.

•Set the TV image mode so that the picture fills the screen. Press the WIDE button on the remote until the screen is filled, and then press OK. See Changing the Screen Aspect Ratio on page 22.

A

The TV has pixels (dots) that are always dark or always lit.

•Your HDTV is precision-manufactured using an extremely high level of technology. However, sometimes pixels may not display correctly. These types of occurrences are inherent to this type of product and do not constitute a defective product.

I see “noise” or static on the screen.

•When your TV’s digital capabilities exceed a digital broadcast signal, the signal is up-converted (improved) to match your TV’s display capabilities. This up-converting can sometimes cause irregularities in the image.

•If you are using an antenna, the signal strength of the channel may be low. Ensure your antenna is connected securely to the TV and move the antenna around the room or close to a window for the best signal.

When I change input source, the volume changes.

•The TV remembers the volume level on each input source. If the volume level on the new input source is higher or lower than the level on the source you switch from, the difference may be noticeable.

•Use the Volume Up/Down buttons on the remote to adjust the volume.

When I change input source, the display image changes size.

•The TV remembers the viewing mode on each input source. If the viewing mode on the new input source differs from the one on the input source you switch from, the difference may be noticeable. See Changing the Screen Aspect Ratio on page 22.

62