XVT3D500CM / XVT3D580CM
To connect to a wireless network whose network name (SSID) is not being broadcast:
1.Press the MENU button on the remote. The
2.Use the Arrow buttons on the remote to highlight the Network icon and press OK. The Network Connection menu is displayed.
3.Highlight Enter Access Point Name and press OK.
4.Using the QWERTY Keypad on the remote, enter your network’s name (SSID), then highlight Connect and press OK. (If you would like to use the
5.Using the QWERTY Keypad on the remote, enter your network’s password, then highlight Connect and press OK. (If you would like to use the
6.Press the EXIT button on the remote.
5
Changing the Advanced Network Settings
Advanced users can
To change advanced network settings:
1.From the Network Connection menu, highlight Manual Setup and press OK. The Change Settings menu is displayed.
2.Use the Arrow and OK buttons to adjust each setting:
•DHCP - (Dynamic Host Configuration Protocol) This setting must be turned Off to change any of the other settings.
•IP Address - The IP address assigned to the TV.
•Subnet Mask - The subnet mask.
•Default Gateway - Your network’s default gateway address.
•Pref. DNS Server - Your preferred domain name server address.
•Alt DNS Server - Your alternate domain name server address.
3.If you need the RJ45 (ethernet) MAC address or the Wireless MAC address to set up your network, these are displayed at the bottom of the Change Settings menu.
4.Press the EXIT button on the remote.
Testing Your Network Connection
To test your network connection:
1.From the Network Connection menu, highlight Test Connection and press OK.
2.The Test Connection screen displays the connection method, network name, signal strength, and download speed of your network connection.
3.Press the EXIT button on the remote.
19
