Vizualogic VL8000 Series VL8000 Kit contents, 12V Power Installation, Module Installation

VL8000 Kit contents:

(1)	Visor with Monitor and Cable	(2)	Batteries, AAA
(1)	A/V Module	(1)	VL8000 Installation Manual
(1)	12V Harness for A/V Module	(1)	VL8000 Owner’s Manual
(1)	Remote Control

12V Power Installation

We recommend the installation of a main power switch for the entire headrest system. The circuit should be marked to assist the consumer in locating the correct vehicle fuse for the video system in the case of a system failure.

AV Module Installation

1.Place A/V module in a well protected area under a seat or behind a panel.

2.Connect the 12V harness to the same 12V+ and 12V Ground as the Video Source Unit(s).

3.Insert 12V harness connector into A/V module.

4.Insert video cable from Source.

5.Insert video output cable connecting the Headrest.

6.Install I/R extender cable from source unit to A/V module.

System Operation

Please see CONTROLS on page 4, 5 and 6 of the VL8000 Owner’s Manual for system operation instructions.

Specifications

ELECTRICAL SPECIFICATIONS – 7.0”
Display Type:	LCD
Screen size:	7.0” (Diagonal)
Resolution:	1,440 (W) x 234 (H)
Number of Pixels:	336,960
Brightness:	400 nit
Horizontal view angle:	±65°
Vertical view angle:	+40°, -65°
Power requirement: (Monitor)	DC 12.0V ±1.5
Power consumption: (Monitor)	DC <1A

Note: Designs and specifications are subject to change without notice and without legal obligation.

Visor Removal Instructions

1. Use a small blade screwdriver	2. With the screwdriver in the	3. Pushing up on the visor will
to insert in access slot to	slot, push the elbow of the	release it form the roof header.
depress the retaining tab.	visor up, towards the roof.
	Lock Position	Service Position

4. Locked Position (installed) 5. Service Position (ready to un-install)

6. With the visor now in service	7. Disconnect lighted	8. Remove shipping ring by
position, pull the visor bracket	mirror wires.	disengaging all 3 locking tabs
down. This will remove the		and do not re-install.
visor completely from the
roof header and headliner.

A-PillAr Trim removAl tip

1. Remove the upper retaining clip from	2. Remove the lower retaining clip from	3. Remove passenger-side A-pillar assist
passenger-side A-pillar assist handle	passenger-side A-pillar assist handle	handle by pulling straight away from the
		A-pillar. Remove passenger-side A-pillar
		trim by pulling at edge of panel.