VocoPro CDG-X3P II Rear panel controls and functions, Rear Panel, Do Not Replace The Fuse

Rear panel controls and functions

Rear Panel

10

12 13 14 15

ECHO BYPASS

DJ MIC VOL BASS TREBLE ECHO

DJ MIC

			3
NTSC	PAL	110-120V	220-240V
VIDEO SYSTEM		VOLTAGE SELECT
SWITCH TO
NTSC FOR U.S. TV SYSTEM			2
PAL FOR EUROPE TV SYSTEM

11

MIC 1-2 CONT

1

9 8 7 6 5 4

1.AC POWER CORD - Plugs into any AC wall outlet.

2.FUSE - IMPORTANT! If the fuse blows out it’s a good indication that there may be a short in the system.

DO NOT REPLACE THE FUSE!

Doing so could possibly cause additional damage to the unit. Take your CDG-X3P II to an authorized repair facillity.

3.117/200W AC OUTLET - This outlet can be used to connect another component providing it does not exceed

200watts maximum power consumption.

4.RECORD OUT TERMINAL – Connect to the audio input jacks of another recording device.

5.VIDEO OUTPUT JACKS - Connect to the video input jacks of a TV monitor.

6.PRE-OUT TERMINAL - Connect to the audio input jacks of an amplifier.

7.LD INPUT JACKS - Connect to the audio and video output jacks of a laser disc player.

8.DVD - Connect to the audio and video output jacks of a DVD player or other audio/video device with RCA outputs.

9.AUX INPUT JACKS - Connect to the audio output jacks of a player.

10.LEFT SPEAKER OUTPUT JACK - Connect to the left speaker using a speaker cable.

Note: The jack is split into positive (+) and negative (-) output jacks but is used as one jack for the right channel only.

11.RIGHT SPEAKER OUTPUT JACK - Connect to the right speaker using a speaker cable.

Note: The jack is split into positive (+) and negative (-) output jacks but is used as one jack for the left channel only.

12.3RD MICROPHONE/DJ/KJ INPUT JACK - This microphone input “bypasses” the echo feature and the bass and treble tones are “preset”. Therefore it is considered to produce a “dry” signal and there are no separate bass or treble controls. It is best used for announcements by the KJ or DJ. The volume control for the 3rd microphone input is located just to the right of the input jack.

13.3RD MICROPHONE INPUT VOLUME CONTROL - This controls the volume for the 3rd microphone input. Turn clockwise to increase volume, counterclockwise to decrease.

14.BASS CONTROL FOR MIC-1 AND MIC-2- This controls the amount BASS tone that microphones 1 and 2 will receive. Turn clockwise to increase bass tone and counterclockwise to decrease the bass tone.

15.TREBLE CONTROL FOR MIC-1 AND MIC-2- This controls the amount TREBLE tone microphones 1 and 2 will receive. Turn clockwise to increase the TREBLE tone and counterclockwise to decrease the treble tone.

15