VocoPro CLG-600 owner manual Unpacking, AC Power Requirements, Mounting Installation

Unpacking

As a part of our system of quality control, every Vocopro product is carefully inspected before leaving the factory to ensure flawless appearance. After unpacking, please inspect for any physical damage. Save the shipping carton and all packing materials, as they were carefully designed to reduce to minimum the possibility of transportation damage should the unit again require packing and shipping. With your new CLG-600, you should have received the following items:

UNPACKING

INAUDIBLE		GAIN	30	27	24	21	18	15	12	9	6	4	2	1		LEVEL	-30	20	-10	-5	-3	0	+3	+5			INAUDIBLE		GAIN	30	27	24	21	18	15	12	9	6	4	2	1	LEVEL	-30	20	-10	-5	-3	0	+3	+5
-	+															CH 1											-	+														CH 2
	-35			-10						2.5			2.5				0.5				0				3			-20			-10						2.5			2.5			0.5				0				3
			-20																								-35			-20
-35	-10					0																						-10					0
-50		0	-30			+10		1.5				8			MANUAL								OUT			MONO	-50		0	-30			+10		1.5				8		MANUAL								OUT
OFF	+10		-40			+20			1			0.1			200	.05		4	-20			+20		OFF	6		OFF	+10		-40			+20			1			0.1		200	.05		4	-20			+20		OFF	6

THRESHOLD

THRESHOLD

RATIO

AUTO

RELEASE

O U P U T

THRESHOLD

THRESHOLD

RATIO

RELEASE

O U P U T

dB

dB

M1

msec

Sec

dB

IN

STEREO

dB

dB

N1

msec

AUTO

Sec

dB

IN

EXPANDER/GATE

COMPRESSOR/LIMITER

ENHANCER

MODE

EXPANDER/GATE

COMPRESSOR/LIMITER

ENHANCER

CLG-600

CLG-600

DUAL CHANNEL COMPRESSOR

LIMITER WITH GATE

AC Main's

Power Cable

AC Power Requirements

A standard IEC-320 AC inlet is provided on the rear panel of the CLG-600 to accept the detachable power cord shipped with the unit. Units are pre-selected for 115 VAC, 60Hz and should be plugged into a standard NEMA 5- 15 3-wire grounded AC receptacle. For use of the unit outside the US, 230VAC, 50-60Hz power supplies are required. The CLG-600 will perform normally from 100 to 125 VAC. An internal line fuse is used. In the event of fuse failure, refer to a qualified service technician for servicing. Power consumption is 9 watts.

Mounting Installation

TOP VIEW

Rack Unit with Empty Space

The CLG-600 mounts in a standard 19-inch equipment rack. The mounting screw threads vary with different rack manufactures and you should refer to your rack instructions for proper hardware. An oval head or flat head screw with a plastic countersink washer is preferred to protect the finish of the CLG-600 under the screw. The CLG-600 is housed in a rugged steel case and can tolerate "in the field" abuse, however proper care will best suit the unit for long-life and performance.

1.To mount, carefully place the CLG-600 in the desired rack space.

2.It is recommended to allow at least 4" of space deep in order to make cable connections easily.

3.Make sure all four holes are aligned evenly.

4.Using an alternating "X" rotation, screw mounting bolts in to ensure even tension and alignment.

6