VocoPro The Bravo Digital CDG and Cassette Karaoke Player listen to your recording...

TO LISTEN TO YOUR RECORDING

1. When you have finished recording stop the tape by pressing the “ST/EJ” key.

2. Rewind the tape by pressing the “REW” key until the tape stops at the desired location.

3. Select the “CASSETTE” button located below the CDG player to switch to cassette mode.

Note: This button should be set to CDG when recording from CDG to cassette.

4. Start the tape playback by pressing the “PLAY” key on the cassette deck.

5 . Adjust the master volume control to the desired listening level. (See ”IMPOR T ANT INFORMA TION” on page 5 )

Reminder: If you set the tape counter to zero before you start recording you can more easily keep track of you location on the tape.

RF MODULATOR

To accommodate those televisions which do not have RCA connectors The Bravo is supplied with an RF modulator.

VOL TAGE SELECT

This is used to select the voltage according to the country. In Europe select 220-224v, in USA select 110v.

VIDEO SYSTEM (NTSC/PAL)

This is used to select the video system according to country. In Europe select PAL, in USA select NTSC.

AC OUTLET

The AC outlet can be used to connect an additional component up to 200W maximum.

FUSE:

IMPORTANT! IF THE FUSE BLOWS OUT IT IS AN IMPORT ANT INDICATION THERE MA Y BE A SHORT SOMEWHERE IN THE

SYSTEM. DO NOT REPLACE THE FUSE! TAKE YOUR BRA VO TO AN AUTHORIZED REP AIR FACILITY. REPLACING THE FUSE

COULD POSSIBL Y CAUSE ADDITIONAL DAMAGE THAT MAY NOT BE COVERED BY THE W ARRANTY .

listen to your recording...