FCC INFORMATION (U.S.A.)
1. IMPORTANT NOTICE: DO NOT MODIFY THIS
UNIT!: This product, when installed as indicated in the
instructions contained in this manual, meets FCC
requirements. Modifications not expressly approved
by Vocopro may void your authority, granted by the
FCC, to use this product.
2. IMPORTANT: When connecting this product to
accessories and/or another product use only high
quality shielded cables. Cable(s) supplied with this
product MUST be used. Follow all installation
instructions. Failure to follow instructions could void
your FCC authorization to use this product in the
U.S.A.
3. NOTE: This product has been tested and found to
comply with the requirements listed in FCC
Regulations, Part 15 for Class "B" digital devices.
Compliance with these requirements provides a
reasonable level of assurances that your use of this
product in a residential environment will not result in
harmful interference with other electronic devices.
This equipment generates/uses radio frequencies
and, if not installed and used according to the
instructions found in the owner's manual, may cause
interference harmful to the operation of other
electronic devices. Compliance with FCC regulations
does not guarantee that interference will not occur in
all installations. If this product is found to be the
source of interference, which can be determined by
turning the unit "Off" and "On", please try to eliminate
the problem by using one of the following measures:
Relocate either this product or the device that is
being affected by the interference.
Use power outlets that are on different branch (circuit
breaker or fuse) circuits or install AC line filter(s).
In the case of radio or TV interference,
relocate/reorient the antenna. If the antenna lead-in is
300-ohm ribbon lead, change the lead-in to coaxial
type cable.
If these corrective measures do not produce
satisfactory results, please contact your local retailer
authorized to distribute Vocopro products. If you can
not locate the appropriate retailer, please contact
Vocopro, 1728 Curtiss Court, La Verne, CA 91750.
(1) To ensure the finest performance, please read this
manual carefully. Keep it in a safe place for future
reference.
(2) Install your unit in a cool, dry, clean place - away
from windows, heat sources, and too much vibration,
dust, moisture or cold. Avoid sources of hum
(transformers, v motors). To prevent fire or electrical
shock, do not expose to rain and water.
(3) Do not operate the unit upside-down.
(4) Never open the cabinet. If a foreign object drops
into the set, contact your dealer.
(5) Place the unit in a location with adequate air
circulation. Do not interfere with its proper ventilation;
this will cause the internal temperature to rise and may
result in a failure.
(6) Do not use force on switches, knobs or cords. When
moving the unit, first turn the un it off. Then gentl y
disconnect the power plug and the cords connecting to
other equipment. Never pull the cord itself.
(7) Do not attempt to clean the unit with chemica l
solvents: this might damage the finish. Use a clean, dry
cloth.
(8) Be sure to read the "Troubleshooting" section on
common operating errors before concluding that your
unit is faulty.
(9) This unit consumes a fair amount of power even
when the power switch is turned off. We recommend
that you unplug the power cord from the wall outlet if the
unit is not going to be used for a long time. This will
save ele ctricity a nd help prevent fire hazards. To
disconnect the cord, pull it out by grasping the plug.
Never pull the cord itself.
(10) To prevent lightning damage, pull out the power
cord and remove the antenna cable during an electrical
storm.
(11) The general digital signals may interfere with other
equipment such as tuners or receivers. Move the
system farther away from such equipment if interference
is observed.
NOTE:
Please check the copyright laws in your country before
recording from records, compact discs, radio, etc.
Recording of copyrighted material may infringe copyright
laws.
CAUTION
The apparatus is not disconnected from the AC power source
so long as it is connected to the wall outlet, even if the
apparatus itself is turned off. To fully insure that the apparatus
is indeed fully void if residual power, leave unit disconnected
from the AC outlet for at least fifteen seconds.
CAUTION:
READ THIS BEFORE OPERATING YOUR UNIT