Telephone base and charger installation
Install the telephone base and charger as shown below.
Telephone base power adapter
Electrical
outlet not 
controlled by a
wall switch
Telephone wall jack
If you have DSL | Charger adapter |
high speed Internet |
|
service, a DSL filter |
|
(not included) is |
|
required. |
|
Electrical outlet not controlled by a wall switch
Telephone line cord
Telephone base | Charger |
•Use only the power adapter and battery supplied with this product. To order a replacement, visit our website at www.vtechphones.com or call 1 (800)
•The power adapter is intended to be correctly oriented in a vertical or floor mount position. The prongs are not designed to hold the plug in place if it is plugged into a ceiling,
Battery installation
Install the battery as shown below.
1Plug the battery connector securely into the socket.
3Slide the battery compartment cover towards the center of the handset until it clicks into place.
2Place the battery with the label THIS SIDE UP facing up and the wires inside the battery compartment.
4Place the handset in the telephone base or charger to charge.
CHARGE light
remains on when charging.
If the handset will not be used for a long time, disconnect and remove the battery to prevent possible leakage.
Battery charging
Once you have installed the battery, the screen indicates the battery status (see the table on the next page).
•For best performance, keep the handset in the telephone base or charger
when not in use.
•The battery is fully charged after 10 hours of continuous charging.
•If you place the handset in the telephone base or the charger without plugging in the battery, the screen displays NO BATTERY.
